0

Out of 0 Ratings

Owner's of the Crown Audio Car Amplifier Crown Audio Car Amplifier gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 32
 
XLC系列功率放大器
Operation Manual
page 7
操作手册
XLC Series Power Ampliers
2.2 Installing the amplifier
NOTE: Before you begin, make sure your amplifier is disconnected from the power source, with
the power switch in the “off” position and all level controls turned completely down (counter-
clockwise).
Use a standard 19-inch (48.3 cm) equipment rack. See Figure 2.2 for amplifier dimensions. You may also stack amplifiers
without using a cabinet.
NOTE: Amplifiers should be supported at both the front and rear of the rack.
2.3 Ensuring Proper Cooling
When using an equipment rack, mount units directly on top of each other. Close any open spaces in rack with blank panels.
Do not block front or rear air vents. The back of the rack should be open.
Figure 2.3 illustrates standard amplifier airflow.
2.2 安装功放
注意:开始安装前,确保您已断开功放与电源的连接,将功放电源开关设置到关闭位
置,并将所有音量调节到最低(逆时针旋转)。
使用一个标准的19寸( 48.3厘米)设备机架。具体功放尺寸请参见图2.2。您还可以直接将功放
安放到平台上,而不用将功放安装到机柜。
注:机架前后均应该支撑功率放大器。
2.3 保证正常散热
在使用设备机架时,直接将设备安装在机架上。使用空白面板将所有开放的空间封闭。不要阻挡
前面和后面的通风口。机架的后面应该保持开放。
图2.3 显示标准的功放气流流通情况。
Figure 2.2 Dimensions
图2.2 尺寸
Figure 2.3 Airflow
图2.3 气流流通
3.46 In.
8.8 cm
18.99 In.
48.25 cm
8.12 In.
20.65 cm
10.38 In.
26.36 cm
XLC2500
XLC2800
XLC
2500
FAULT
CLIP
SIGNAL
CH 2
CH 1
2. 安装(接上一页)
2. Setup (continued)