Fostex DVR FR-2 User Manual

0

Out of 0 Ratings

Owner's of the Fostex DVR FR-2 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 110
 
52
FR-2
Field Memory Recorder (Chapter 5: Recording/playback)
You can monitor recording signals via headphones (or the internal monitor speaker).
Inserting a plug to the [PHONES] jack automatically disengages the internal speaker,
and you can monitor the signals only via headphones.
The monitor level can be adjusted by the [SP/HP MONITOR] control. This control
is a pushlock type. Pressing on the control knob raises it above the panel to permit
level adjustment. Pressing the control again recesses the knob to avoid accidental
setting changes.
To turn off the monitor sound completely, rotate the control fully counterclock-
wise until it clicks.
<Note>:
While operating the FR-2 on batteries, we recommend not to raise the monitor
volume more than required. Raising the volume consumes more battery power.
Monitoring recording signals
When recording in mono
You can monitor the recorded signal in mono (center panning) via the [PHONES]
jack.
When recording in stereo You can monitor the recorded signal in stereo via the [PHONES] jack.
You can see the remaining time or space (in MBytes) of the current memory card
(by default, remaining time).
Checking the remain for recording
Any condition except
during recording and
input monitor
The total remaining time or space of the current memory card is shown.
During recording and
input monitor
When the remaining space is more than 2 GBytes,
"2000MB" or the equivalent time value is shown.
When the remaining space
of the current memory card
is more than 2 GBytes
When the remaining space
of the current memory card
gets less than 2 Gbytes
The current remaining time or space is shown.
The remaining space is shown.
The remaining time is shown.
The remaining time is calculated based on the current [FS (kHz)] and [QUANTIZA-
TION] switch settings.
Depending on the recorder status, the display shows the remaining value as fol-
lows.
<Note>: The remaining time is shown in "*h**m" when it is over 60 minutes, while it is shown in "**m**s"
when it lowers 60 minutes.

   Find Your Products By Category